Brother International HS-5300 Service Manual - Page 21
Logic, circuits, Solenoids, motor, Heater, Carriage, Print
View all Brother International HS-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
1.2 Configuration of Electronics (1) Control PCB Receives the data and controls the PA and carriage motors, solenoids, platen heater, switch panel, paper sensing, head temperature, platen temperature head voltage, PS fan motor and fan motor. It also detects the amount of ink remaining, the maintenance PE and sends the data to the head driver. (2) Driver PCB Drives the PA and carriage motors, solenoids, LEDs on the switch panel, platen heater, head heater, ink remaining detection circuit, PS fan motor, fan motor, head and sensors. (3) Panel PCB Three switches and five LEDs are mounted on this PCB. (4) CR PCB Connects the driver PCB to the following parts on the carriage. Paper width sensor, encoder, head heater, head OHS heater and LOIS circuit (5) Power supply unit: Generates voltages as below. Head drive ICs are mounted on the head and connected to the driver PCB through the CR PCB. 5V 25V 52V 39 / 30V : Logic circuits Solenoids PS fan motor Fan motor Heater Carriage motor Print head PA motor 11-2