Brother International HS-5300 Service Manual - Page 27
controlled
View all Brother International HS-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
1.4.3 Solenoid Drive Circuit The HS-5000 uses one solenoid while the HS-5300 uses three solenoids. In the HS-5000, the solenoid is activated to rotate the paper feed roller for paper feeding. In the HS-5300, the solenoids are activated to rotate the paper feed roller (1st bin or 2nd bin) for paper feeding or to stop rotation of the regist roller. Engine CPU < Main PCB Jet > ASIC3 Driver PCB +25V P8 SOL_B SOL C Solenoid Drive SOL A Circuit P7 Fig. 2.5 When the SOL_A signal is high, the paper feed roller for the 1st bin starts rotating. When SOL_B signal is high, the paper feed roller for the 2nd bin starts rotating. When SOL_C signal is high, the regist roller stops rotating. 1.4.4 Switch Panel Control Circuit The switch panel control circuit controls the input from the three buttons and the ON/OFF status of the five LEDs. When a button is pressed, the switch signal becomes low and it is detected by the engine CPU through the Jet ASIC3. The ON/OFF status of each LED is controlled by the engine CPU. When the status signal is low, the LED is lit. Engine CPU Main PCB Jet < > ASIC3 Driver PCB I Panel PCB > LED SW FF SW RESET SW ONLINE Fig. 2.6 11-8