Brother International HS-5300 Service Manual - Page 151
Brother International HS-5300 Manual
View all Brother International HS-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
3.3 Error Codes 5 There are 2 kinds of error code. Operator calls: Alarm LED and specific LED(s) blink alternately. Service calls: All the LEDs and specific LED(s) go ON alternately. PR98064 The specific combination of ON or blinking indicates the type of the error. Operator calls Paper Empty Paper Jam Ink Empty Maintenance Paper Short Cover Open Memory full CDCC Line Error MIO Error SIMM Error Alarm Manual Data LED LED LED * X X * X X * X * * * X * X X * X X * X X * X X Ready LED * * X X X X X X : Blinkin Note O : ON X : OFF No paper in the sheet feeder(s), or paper is not picked up correctly. Paper is jamming An ink is empty The maintenance paper has run out. The top cover is open. A memory full error occurred. (An error print sheet is printed out.) a CDCC I/F communication error A SIMM or the MIO board is not installed correctly. (An error print sheet is printed out.) Service calls Alarm Manual Data Ready LED LED LED LED ROM Error O RAM Error X NVRAM Error O Controller Service Error X ASIC Error O Engine ROM Error X Engine RAM Error O Engine Program Error X Communication Error O Paper Width Sensor Error X Paper Width Level Error O Paper Dust Error X CAM Position Error O LOIS Error X Carriage Position Error / O PWM Error Carriage Lock . X Carriage Initialize Error O X X X O 'X X O X X X O X X O X X X O X X O O X O O X O X O O X O O O O O O O O X X X X X X O X. X O X X Encoder Error Thermistor Error Heater Overheat Error Heater Break Error AC Heater Error Quench Platen Error X XOX O X O- X X O O X O O O X X X X O O X X O Power LED X X X X X X X X X X X X X O O O O O O O O O O Note ROM Check sum Error RAM Read/Write Error NVRAM Read/Write Test Error CPU Runtime Error ASIC Error Engine ROM Check sum error Engine RAM ReadANrite Error Engine Program Error Main communication error Unable to detect paper width Failure of paper width sensor level Paper dust on paper width sensor Unable to detect the CAM position Short or Open circuit of LOIS Wrong carriage position / abnormal PWM The carriage is locked. Cannot detect a carriage home position / There are foreign objects in the sensor. Something wrong with the encoder / Dirt on the encoder. Short or Open circuit of the thermistors. Overheating of the heaters. Short circuit of the heaters Abnormal supply of AC heater The temperature at the quench platen does not go down. IV-17