Brother International HS-5300 Service Manual - Page 97
electrode, support, Carriage, cable, Encoder, harness, heater, Front, sensor, Lois-FFC
View all Brother International HS-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
(3) Fit the AC electrode support C ASSY with the two screws. Note: Make sure that the left flange of the AC electrode support C ASSY holds the FFC cables in place. AC electrode support C ASSY 7 Carriage ASSY FFC cable Fig. 4.71 (5) Fit the CR PCB ASSY to the connector position on the Head ASSY. Push the CR PCB ASSY towards the upper left hand corner as shown in fig. 4.72. (6) At this time, check that the front end heater harness and the PW sensor harness are secured by the hooks on the Head ASSY as shown in the enlarged figure. (7) Reassemble the CR PCB cover onto the Carriage ASSY. Note: At this time, carefully reassemble the CR PCB cover so that the headFFC cable is not damaged Make sure that the ENC harness is correctly inserted into the notch of the Relay PCB cover. Encoder harness Front end heater harness O r Back end heater harness OHS heater harness Push Push L PW sensor harness O 1' Lois-FFC PW sensor harness Fig. 4.72 Front end heater III-45