Brother International HS-5300 Service Manual - Page 143

3. INSPECTION MODE 3.1 Extended Functions The following two extended functions will be executed by holding down the online switch or the FF/Cont switch for 4 seconds or more regardless of online or offline status. 3.1.1 Self Printing Mode The printer goes into the self printing mode by holding down the online switch for 4 seconds or more. Immediately after entering this mode, the Alarm LED blinks. Every time the online switch is pressed, the lit LED position steps on to the next position. The following self printing tests are assigned to the respective LED. By pressing the FF/Cont switch, the self printing will be executed. As soon as the self printing is done, the printer will return to ready status. 1 ALARM LED blinking Online 1 MANUAL LED blinking Online 1 DATA LED blinking Online I READY LED blinking Online FF/Cont FF/Cont FF/Cont FF/Cont ► Print Config ► Print Fonts I ► Print Fonts P ► Reserved 3.1.2 Reset and HEX Dump Mode The printer performs a reset or goes into the HEX dump mode by holding down the FF/Cont switch for 4 seconds or more. Immediately after entering this mode, the Alarm LED blinks. Every time the online switch is pressed, the lit LED position steps on to the next position. The following actions are assigned to the respective LED. By pressing the FF/Cont switch, the selected function will be executed. Although it will return to the ready status after reset, it is necessary to reset by turning off the power switch or pressing the reset switch to quit the HEX dump mode. 1 ALARM LED blinking Online 'Jr MANUAL LED blinking Online 'Jr DATA LED blinking Online 'Jr READY LED blinking Online FF/Cont_ ► User Reset FF/Cont_ ► Factory Reset FF/Cont ► HEX Dump Mode FF/Cont ► Reserved IV-9