HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 152

For each VLUN created, the .int suffix of the VV_name specifier and LUN are incremented by one. -novcn Specifies that a VLUN Change Notification (VCN) not be issued after export. For direct connect or loop configurations, a VCN consists of a Fibre Channel Loop Initialization Primitive (LIP). For fabric configurations, a VCN consists of a Registered State Change Notification (RSCN) that is sent to the fabric controller. -ovrd Specifies that existing lower priority VLUNs will be overridden, if necessary. Can only be used when exporting to a specific host. SPECIFIERS Specifies the VV name or VV set name, using up to 31 characters in length. The volume name is provided in the syntax of basename.int. The VV_set name must start with set:. Specifies the LUN as an integer from 0 through 16383. Alternatively + can be used to indicate a LUN should be auto assigned, but be a minimum of n, or n-m to indicate that a LUN should be chosen in the range n to m. In addition the keyword auto may be used and is treated as 0+. Specifies the host where the LUN is exported, using up to 31 characters. Specifies the host set where the LUN is exported, using up to 31 characters. Specifies the system port of the virtual LUN export. node Specifies the system port, where the node is a number between 0 and 7. slot Specifies the PCI bus slot in the node, where the slot is a number between 0 and 5. port Specifies the port number on the FC card, where the port number between 1 and 4. RESTRICTIONS None. EXAMPLES The following example exports VV test on LUN 2: cli% createvlun test 2 testhost NOTES • If a volume is already exported as a VLUN, you will be prompted for confirmation if a new export of the same volume is attempted. • The host and port can both be supplied when issuing this command (matched set). This is the most restrictive access as both the host name and port must match before access to the VLUN is granted. 152 Create Commands