HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 465
ready, missing, N:S:P, node:slot:port, State, incomplete, HwAddr, IPAddress, PeerIPAddress, Netmask
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 465 highlights
◦ ready. Configuration is completed on this port and the peer port; transport is ready for use. ◦ missing. A configured transport was disconnected. • Type. Indicates the port connection type. ◦ rcip. Port is used for Remote Copy over IP (RCIP). ◦ rcfc. Port is used for Remote Copy over FC (RCFC). The following example displays status and information about the end-to-end transport for RCIP ports: # showrctransport -rcip N:S:P State HwAddr IPAddress PeerIPAddress Netmask Gateway MTU Rate Duplex 0:1:1 new 000423C21B72 192.168.25.226 - 255.255.255.0 - 1500 1Gbps Full 0:1:1 new 000423C21B73 192.168.25.226 - 255.255.255.0 - 1500 n/a Half 1:2:1 new 000423ADE95E 192.168.25.227 - 255.255.255.0 - 1500 1Gbps Full 1:2:1 new 000423ADE95F 192.168.25.227 - 255.255.255.0 - 1500 n/a Half The columns in the previous example are identified as follows: • N:S:P. The physical position of the port, in the syntax node:slot:port. • State. Remote copy end-to-end transport state. Can include one of the following results: ◦ new. Configuration is not completed on this port. ◦ incomplete. Configuration is not yet completed on the peer port. ◦ ready. Configuration is completed on this port and the peer port; transport is ready for use. ◦ missing. A configured transport was disconnected. • HwAddr. Hardware address of the Ethernet port indicated in the N:S:P column. • IPAddress. IP address of the Ethernet port indicated in the N:S:P column. • PeerIPAddress. IP address of the peer Ethernet port to which the port indicated in the N:S:P column is connected. • Netmask. Netmask for the IP address. • Gateway. Address of the gateway. • MTU. Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is 1500). The largest supported value is 9000 and the smallest is 100. • Rate. Actual bit rate of the port indicated in the N:S:P column. • Duplex. Values can be either Full or Half. The following example displays status and information about the end-to-end transport for RCFC ports: # showrctransport -rcfc N:S:P Remote_Node_WWN Remote_Port_WWN 5:3:2 2FF70002AC000029 21110002AC000029 4:1:1 2FF70002AC000029 20020002AC000029 State ready ready showrctransport 465