HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 613

Specifies that I/O averages are computed from the system start time. If not specified, the average is computed since the first iteration of the command. -idlep Specifies the percent of idle columns in the output. -sortcol [,][:[,]...] Sorts command output based on the column number (). Columns are numbered from left to right, beginning with 0. At least one column must be specified. In addition, the direction of sorting () can be specified as follows: inc Sort in increasing order (default). dec Sort in decreasing order. Multiple columns can be specified separated by a colon (:). Rows that have the same information in them as earlier columns will be sorted by the values in the later columns. -filt Specifies that statistics that fall below the threshold as specified by the arguments where is , , , , are filtered out and not displayed. The -filt option applies to data transfers only. The ,, , and arguments are separated with one comma. • The type argument can be specified with one of the following arguments: ◦ curs Specifies that only devices with current statistics above the threshold are displayed. ◦ avgs Specifies that only devices with average statistics above the threshold are displayed. ◦ maxs Specifies that only devices with maximum values above the threshold are displayed. • The op (operation) argument can be specified with one of the following arguments: ◦r Specifies that read-only statistics are displayed. ◦w Specifies that write-only statistics are displayed. ◦ t|rw Specifies that statistics for read and write totals are displayed. statport 613