HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 304

Specifies the IP address of the new gateway for the system. This specifier can only be used with the startgateway subcommand. auto| Specifies that the speed of the network interface is either auto negotiated (auto), or specified manually using the and specifiers. Specifies the speed of the network interface. Valid values are either 10 or 100. This specifier can only be used with the specifier and with the speed subcommand. Specifies the duplex of the network interface. Valid values are either half or full. This specifier can only be used with the specifier and with the speed subcommand. Specifies the IP address of the node. This specifier can only be used with the failoverping subcommand. |none Specifies that during an IP failover, a ping either be sent to the specified IP address () or not sent at all (none). This specifier can only be used with the failoverping subcommand. [] Specifies the node, by ID, that has an active Ethernet interface. This specifier can only be issued with the changenode subcommand. This specifier is not required. RESTRICTIONS Access to all domains is required to run this command. EXAMPLES The following example displays the switching of the old IP address with a new IP address and netmask: cli% setnet startaddr 10.0.23.42 192.168.5.218 255.255.252.0 Change of IP address successfully started. The following example displays the gateway being cleared: cli% setnet cleargateway If the machine that the HP 3PAR CLI is running on is not on the same subnet as the HP 3PAR storage system it is connected to, clearing the gateway will render the storage system unreachable from that machine, and any future connections will need to be made from a system which is on the same subnet as the system. Are you sure you want to clear the gateway (y/n)? y Gateway modified successfully. 304 Set Commands