HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 324

setsnmpmgr DESCRIPTION The setsnmpmgr command changes an SNMP manager's properties. SYNTAX The syntax for the setsnmpmgr command can be one of the following examples: • setsnmpmgr [options ] AUTHORITY • Super • Any role granted to the snmpmgr_set right NOTE: You need access to all domains in order to run this command. OPTIONS -p Specifies the port number where the SNMP manager receives traps. The port number and IP address are used together to uniquely identify the SNMP manager. Use this option if the port number differs from the default of "162". -pw Specifies the SNMP manager's access community string (password), using up to 32 alphanumeric characters. If not specified, the default is "public". -snmpuser Specifies the SNMPv3 user name using up to 31 characters. The user name must be enabled for SNMPv3 with the createsnmpuser command. -version Integer value that specifies the SNMP version supported by the manager. Use "2" for SNMPv2 and "3" for SNMPv3. The default is "2". SPECIFIERS Specifies the IP address of the host where the manager runs. It must be valid IPv4 or IPv6 address. IPv6 address is in hexadecimal, is case insensitive, and is separated by colons. An example would be: 5def:2008:0:0:abcd:0:0:161a. In addition, a double colon (::) can be used once in an address to replace multiple fields of zeros. For example: 5def:2008:0:0:abcd::161a. EXAMPLES The following example modifies the SNMP manager IPv4 address 123.45.67.89 with the assigned password of alpha1: cli% setsnmpmgr -pw alpha1 123.45.67.89 324 Set Commands