HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 209
locatesys, Specifies a comma-separated list of nodes on which to blink LEDs. The default is all nodes.
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
locatesys DESCRIPTION The locatesys command helps locate a storage system by blinking the node status LEDs on all nodes of a storage system alternating between amber and green. By default, the LEDs in all connected cages are also set as amber or oscillating (depending on the cage). SYNTAX locatesys [options ] AUTHORITY • Super, Service • Any role granted the sys_locate right. NOTE: You need access to all domains in order to run this command. OPTIONS -t Specifies the number of seconds to blink the LEDs. The default is 60 seconds; the maximum is 255 seconds. -nodes Specifies a comma-separated list of nodes on which to blink LEDs. The default is all nodes. -nocage Specifies that LEDs on the drive cages should not blink. The default is to blink LEDs for all cages in the system. SPECIFIERS None. RESTRICTIONS Access to all domains is required to run this command. EXAMPLES In the following example, an HP 3PAR Storage System is identified by blinking the LEDs on all drive cages in the system for 90 seconds. cli% locatesys -t 90 NOTES None. locatesys 209