HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 42

3 Add Command addsnmpmgr DESCRIPTION The addsnmpmgr command adds an SNMP manager to receive alert (traps) notifications. WARNING! SNMP cannot be used in Common Criteria mode. It might compromise the security of the storage system. SYNTAX addsnmpmgr [options ] AUTHORITY • Super • Any role granted the snmpmgr_add right. NOTE: You need access to all domains in order to run this command. OPTIONS -p Specifies the port number where the SNMP manager receives traps. This option is used if the port number differs from the default of 162. -pw Specifies the SNMP manager's access community string (password), using up to 32 alphanumeric characters. If unspecified, the agents send traps without an access password. -r Specifies the number of times to send a trap () using an integer from 1 through 15 if the SNMP manager is not available. If not specified, the number of times a trap is sent defaults to 2. -snmpuser Specifies the SNMPv3 user name using up to 31 characters. The user name must be enabled for SNMPv3 with the createsnmpuser command. -t Specifies the number of seconds to wait before sending a trap (timeout) using an integer from 1 through 300. If not specified, the time defaults to 200 seconds. -version Integer value that specifies the SNMP version supported by the manager. Use "2" for SNMPv2 or "3" for SNMPv3. The default is "2". SPECIFIERS Specifies the IP address of the host where the manager runs. It must be a valid IPv4 or IPv6 address. The IPv6 address is in hexadecimal, is case insensitive, and is separated by colons. For example: 5de:2008:0:0abcd:0:0:161a In addition, a double colon (::) can be used once in an address to replace multiple fields of zeros. For example: 42 Add Command