HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 445
VLUN State Change Notification support setting. Valid values are, link_idle_for_reset
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 445 highlights
• ConnType. Indicates the type of connection configured for the port; loop for loop, point for point-to-point, or lp for loop or point-to-point. • CfgRate. The configurable bit rate of data transfer between the port and a host or a disk; either auto, 1Gbps, 2Gbps, or 4Gbps. • MaxRate. Indicates the maximum bit rate of transfer between the HBA and the host or disk. • Class2. Identifies whether class 2 is enabled (ack0 or ack1) or disabled. • VCN. VLUN State Change Notification support setting. Valid values are n/a, enabled or disabled. When enabled and in public loop or fabric topology, a Registered State Change Notification (RSCN) message is issued to the fabric controller whenever a VLUN is created or removed. • IntCoal. Indicates whether the interrupt coalesce setting is Enabled or Disabled. The following example displays information about all Remote Copy ports: cli% showport -rc N:S:P State HwAddr Rate Type 5:3:2 ready 25320002AC000006 2Gbps rcip 4:1:1 ready 24110002AC000006 2Gbps rcip 0:5:1 ready 0002B39B2013 100Mbps rcip The columns in the previous example are identified as follows: • N:S:P. The physical position of the port, in the syntax node:slot:port. • State. State of the port. ◦ config_wait. Configuration waiting. ◦ alpa_wait. ALPA waiting. ◦ login_wait. Login waiting. ◦ ready. Link is ready. ◦ loss_sync. Link loss sync. ◦ error. Currently in an error state. ◦ non_participate. Link not participating. ◦ taking_coredump.Coredump in progress. ◦ offline. Link is offline. ◦ fw_dead. Firmware dead. ◦ link_idle_for_reset. Link is idle for reset. ◦ dhcp_in_progress. DHCP is in progress. ◦ pending_reset. Link reset is pending. ◦ unknown. Link state is unknown. • HwAddr. A unique identifier of the port hardware used for Remote Copy connection. For an RCIP port, it is the MAC address of the port. • Rate. Data transfer rate (bitrate) for the Remote Copy interface. showport 445