HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 302
setnet, Service, Super
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
setnet DESCRIPTION The setnet command sets the administration network interface configuration. AUTHORITY • Service, Super • Any role granted the net_set right. NOTE: You need access to all domains in order to run this command. SYNTAX The syntax for the setnet command can be one of the following: • setnet startaddr • setnet startgateway • setnet finish [-f] • setnet abort • setnet cleargateway [-f] • setnet speed auto| • setnet failoverping |none • setnet ntp none| • setnet changenode [] • setnet addaddr | • setnet removeaddr • setnet dns none| SUBCOMMANDS startaddr Specifies that the system start switching the old IP address ( specifier) to the new IP address ( specifier) with the specified netmask ( specifier). startgateway Specifies that the gateway be immediately set to the specified IP address if no gateway is currently defined, or switched to the specified IP address if currently defined, in both cases indicated with the ( specifier). finish Specifies that outstanding changes from the startaddr and startgateway subcommands be completed. abort Specifies that any attempt to configure a new IP address or gateway fails. The system returns to its previous state. cleargateway Specifies that the existing system gateway is removed. speed 302 Set Commands