HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 336

setsysmgr DESCRIPTION The setsysmgr command sets the system manager startup state. CAUTION: Issuing the setsysmgr command can potentially remove the entire state of the system causing data loss. SYNTAX The syntax of the setsysmgr command can be one of the following: • setsysmgr wipe [-f] [] • setsysmgr tocgen [-f] [ []] • setsysmgr force_iderecovery [-f] • setsysmgr force_idewipe [-f] AUTHORITY • Super • Any role granted the sysmgr_set right. NOTE: You need access to all domains in order to run this command. SUBCOMMANDS wipe Requests that the specified system be started in the new system state. If this subcommand is not used, then the tocgen subcommand must be used. tocgen Specifies that the system is to be started with the specified table of contents generation number. If this subcommand is not used, then the wipe subcommand must be used. force_iderecovery Specifies that the system starts the recovery process from the IDE disk even if all Virtual Volumes (VV) have not been started. CAUTION: Issuing the setsysmgr force_idewipe command can result in data loss. force_idewipe Specifies that the system wipes the IDE powerfail partition. The system is shutdown and restarted, during which time all logical disks and VVs are checked. OPTIONS -f Specifies that the command is forced. If this option is not used, the command requires confirmation before proceeding with its operation. SPECIFIERS Specifies the name of the system to be started, using up to 31 characters in length. 336 Set Commands