HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 17

AUTHORITY This section defines the user access required within the HP 3PAR Storage System to use the command. SUBCOMMANDS This section indicates any necessary subcommands required to complete the use of the command. SYNTAX See Section (page 11). OPTIONS This section lists the available options you can use in conjunction with the command for varied results. Some options and their specifiers are required, as indicated in the syntax, whereas some are provided to increase the level and functionality of your output. SPECIFIERS Specifies a suggested input required by the user. RESTRICTIONS This section includes any restrictions that must be followed in order to achieve maximum results. EXAMPLES This section lists sample output with results similar to what you should expect when running the command and it's available options. NOTES Any pertinent information about the command that might help increase understanding and reliability is often provided in the Notes section. Global Options and Environment Variables Several options and environment variables are available at the global level. For complete information about these, refer to the HP 3PAR OS CLI Administrator's Manual. Exit Status Except where noted, the following codes are returned indicating success or failure for each individual command: • 0 indicates that the command was successful. • 1 indicates that the command failed. Note that these exit status codes only indicate the execution status of the command itself. The results of individual CLI commands should be determined from the command output. For example, if you issue the addsnmpmgr command with an invalid IP address, the command output returns Invalid IP address and an SNMP manager is not added; however, the exit status is 0 (successful) because the command itself was successfully executed, even though the intended result of the command (adding an SNMP manager) was not achieved. Global Options and Environment Variables 17