HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 443
Port is used for Fibre Channel over Ethernet FCoE., Port_WWN/HW_Addr
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 443 highlights
◦ loss_sync. Link loss sync. ◦ error. Currently in an error state. ◦ non_participate. Link not participating. ◦ taking_coredump.Coredump in progress. ◦ offline. Link is offline. ◦ fw_dead. Firmware dead. ◦ link_idle_for_reset. Link is idle for reset. ◦ dhcp_in_progress. DHCP is in progress. ◦ pending_reset. Link reset is pending. ◦ unknown. Link state is unknown. • Node_WWN. The WWN that belongs to the controller node identified in the N:S:P column. • Port_WWN/HW_Addr. The WWN that belongs to the controller node port identified in the N:S:P column. • Type. Indicates the port connection type. ◦ host. Port is connected to hosts. This port can also be used for Remote Copy over IP (RCIP). ◦ disk. Port is connected to disks. ◦ rcfc. FC port is used for Remote Copy. ◦ peer. FC port is used for data migration. ◦ rcip. IP port is used for Remote Copy. ◦ iscsi. iSCSI port connected to hosts. ◦ free. Port is not connected to hosts or disks. ◦ fcoe. Port is used for Fibre Channel over Ethernet (FCoE). • Protocol. Indicates the protocol type. ◦ FC Fibre Channel ◦ FCoE Fibre Channel over Ethernet ◦ IP Internet Protocol (Remote Copy) ◦ iSCSI iSCSI ◦ - No mode selected (for CNA ports) • Label. Configurable, human-readable label identifying the HBA port showport 443