HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 68
If you are running the checkrclink test on RCFC links, note the IP address displayed in
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Specifies the port on which to run the test. If this specifier is not used, the test automatically runs on port 3492. RESTRICTIONS The Remote Copy ports must be configured via the controlport command before this test can be carried out; however, this test can be performed before links are admitted into the Remote Copy target system. EXAMPLES The following example displays a 60-second latency and throughput check of SystemA to SystemB: SystemB# checkrclink startserver 0:6:1 10.100.33.63 SystemA# checkrclink startclient 2:5:1 10.100.10.10 60 . . . TEST SUMMARY from 0:0:1 -> 10.100.18.164 Test Started: Wed Aug 10 10:34:15 PST 2011 Test Finished: Wed Aug 10 10:34:26 PST 2011 Latency: Lost pings: Through-put: Max MTU: Tx TCP Segs: Rx TCP Segs: TCP retrans: Errored Segs: 0.104 ms 0 % 522 Mbits/second 1500 486675 199271 0 % 0 % Link 2:5:1 is SUITABLE for Remote Copy Use SystemB# checkrclink stopserver NOTES • Do not check the links if CPU usage is already close to 100%. The link check temporarily increases CPU usage. • This test must be performed in two stages. To run a test between SystemA and SystemB: a. Start the system on SystemB, specifying the for SystemB and the for SystemA. # checkrclink startserver If you are running the checkrclink test on RCFC links, note the IP address displayed in the output. b. Start the client on the target system (SystemA), specifying the for SystemA; the for SystemB (as an IP address for both RCIP and RCFC links); and the duration of the test in seconds. # checkrclink startclient 68 Check Commands