HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 53
On the secondary system the, In the following example,
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
In the following example, the admitrcopyvv command adds all the volumes that start with the name testvv to the primary volume group Group1. At the same time, it adds all the volume testvv*.r on the target system InServ1_in to the corresponding secondary volume group that was previously created when the creatercopygroup command was issued. It also specifies that each volume should be synchronized using rosv_testvv* as the starting snapshot: cli% admitrcopyvv -pat testvv*:rosv_@vvname@ Group1 InServ1_in:@[email protected] NOTES • A secondary volume mapping must be provided for each target in the group. • The virtual volume and the Remote Copy group must be in the same domain or both in no domain. • The -nosync option will skip the full synchronization of this volume after the Remote Copy group is started. On the primary system, the showrcopy SyncStatus will appear as New-PreSynced. On the secondary system, the SyncStatus will appear as New. • When a starting snapshot is specified, any deltas between the specified snapshot and the point when the group is started will be resynced. This is done instead of a full synchronization. On the primary system the showrcopy SyncStatus will appear as New-SyncFromSnap. On the secondary system the SyncStatus will appear as New. • If the -nosync option is not used and a starting snapshot is not specified, the volume will undergo a full synchronization when the group is started. The showrcopy SyncStatus will appear as New on both primary and secondary systems. • If a group's target has the mirror_config policy set and the group is a primary group, then this command is mirrored to that target and the volume is added to the secondary volume group. If the policy is set and the group is a secondary, this command fails. • For multiple target Remote Copy groups, in addition to adding the primary/secondary mapping on the target systems, the relevant mapping between the target systems will be added to the backup groups. admitrcopyvv 53