HP 3PAR StoreServ 7400 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 67

checkrclink DESCRIPTION The checkrclink command performs a connectivity, latency, and throughput test between two connected HP 3PAR storage systems. SYNTAX • checkrclink startclient [] • checkrclink stopclient • checkrclink startserver [] [] • checkrclink stopserver • checkrclink portconn AUTHORITY • Super, Service • Any role granted the rclink_check right. NOTE: You need access to all domains in order to run this command. SUBCOMMANDS startclient Starts the link test. stopclient Stops the link test. startserver Starts the system. stopserver Stops the system. portconn Uses the Cisco Discovery Protocol Reporter to show display information about devices that are connected to network ports. Requires CDP to be enabled on the router. The checkrclink test must be performed in two stages. For more information, see NOTES. OPTIONS None. SPECIFIERS Specifies the interface from which to check the link, expressed as node:slot:port. Specifies the address of the target system (for example, the IP address). Specifies the test duration in seconds. [] checkrclink 67