HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 111

Chapter 1 CLI Overview Using the File System Send documentation comments to [email protected] 20971520 bytes total switch# gzip volatile:Samplefile switch# dir 266069 Jul 04 00:51:03 2003 Samplefile.gz Usage for volatile:// 266240 bytes used 20705280 bytes free 20971520 bytes total The gunzip command uncompresses (unzips) LZ77 coded files. This example unzips the file that was compressed in the previous example: switch# gunzip samplefile /volatile/samplefile.gz: No such file or directory switch# gunzip Samplefile switch# dir 1525859 Jul 04 00:51:03 2003 Samplefile Usage for volatile:// 1527808 bytes used 19443712 bytes free 20971520 bytes total Displaying the Last Line in a File The tail command displays the last lines (tail end) of a specified file. The syntax for this command is tail [] switch# tail mylog 10 You see the last 10 lines of the mylog file. Executing Commands Specified in a Script The run-script command executes the commands specified in a file. To use this command, be sure to create the file and specify commands in the required order. Note You cannot create the script files at the switch prompt. You can create the script file on an external machine and copy it the bootflash: directory. This section assumes that the script file resides in the bootflash: directory. The syntax for this command is run-script file_name This example displays the CLI commands specified in the testfile that resides in the slot0 directory. switch# show file slot0:testfile conf t interface fc 1/1 no shutdown end sh interface fc1/1 This file output is in response to the run-script command executing the contents in the testfile file: switch# run-script slot0:testfile 'conf t' Enter configuration commands, one per line. End with CNTL/Z. OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 1-37