HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 90

Navigating Through CLI Commands Chapter 1 CLI Overview Send documentation comments to [email protected] Table 1-6 Port Mapping Between the Cisco MDS 9000 Family and the Cisco Fabric Switch for IBM BladeCenter Cisco MDS 9000 Family Port fc1/1 fc1/15 fc1/16 fc1/17 fc1/18 fc1/19 fc1/20 Cisco Fabric Switch for IBM BladeCenter Port ext19 bay4 bay2 bay3 ext0 bay1 ext15 Port Group PortGroup 1 PortGroup 5 When you enter commands that require port names for the Cisco Fabric Switch for HP c-Class BladeSystem or the Cisco Fabric Switch for IBM BladeCenter, use the appropriate naming convention from either Table 1-5 or Table 1-6. See Example 1-2 and Example 1-3 for typical commands that require port names. Example 1-2 interface Command switch# config t Enter configuration commands, one per line. chester-1(config)# interface ext2 chester-1(config-if)# End with CNTL/Z. Example 1-3 show interface Command switch# show interface bay 5 Entering CLI Commands You can configure the software in one of two ways: • You can create the configuration for the switch interactively by issuing commands at the CLI prompt. • You can create an ASCII file containing a switch configuration and then load this file on the required system. You can then use the CLI to edit and activate the file. (Refer to the Cisco MDS 9000 Family CLI Configuration Guide for further information.) Viewing Switch Configurations You can view the ASCII form of the configuration file when required. To view the current configuration tree from the EXEC prompt, issue the show running-config command. If the running configuration is different from the startup configuration, issue the show startup-config command to view the ASCII version of the current startup configuration that was used to boot the switch. 1-16 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x