HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 573

Chapter 8 F Commands fspf config vsan Send documentation comments to [email protected] Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines This command configures FSPF on VSANs globally. For the commands issued in FSPF configuration mode, you do not have to specify the VSAN number every time. This prevents configuration errors that might result from specifying the wrong VSAN number for these commands. Examples The following example configures FSPF globally in VSAN 1, deletes the FSPF configured in VSAN 3, disables FSPF in VSAN 5, and enables FSPF in VSAN 7. switch## config terminal switch(config)## switch(config)# fspf config vsan 1 switch-config-(fspf-config)# spf static switch-config-(fspf-config)# exit switch(config)# switch(config)# no fspf config vsan 3 switch(config)# Related Commands Command show fspf interface fspf enable fspf cost fspf hello-interval fspf passive fspf retrasmit Description Displays information for each selected interface. Enables FSPF routing protocol in the specified VSAN (from the switch(config-if)# prompt). Configures the cost for the selected interface in the specified VSAN (from the switch(config-if)# prompt). Specifies the hello message interval to verify the health of a link in the VSAN (from the switch(config-if)# prompt). Disables the FSPF protocol for the specified interface in the specified VSAN (from the switch(config-if)# prompt). Specifies the retransmit time interval for unacknowledged link state updates in specified VSAN (from the switch(config-if)# prompt). OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 8-83