HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 1547

Chapter 27 Z Commands zoneset (configuration mode) Send documentation comments to [email protected] zoneset (configuration mode) To group zones under one zone set, use the zoneset command in configuration mode. To negate the command or revert to the factory defaults, use the no form of the command. zoneset {activate name zoneset-name vsan vsan-id | clone zoneset-currentName zoneset-cloneName | distribute full vsan vsan-id | name zoneset-name vsan vsan-id | rename current-name new-name vsan vsan-id} no zoneset {activate name zoneset-name vsan vsan-id | clone zoneset-currentName zoneset-cloneName | distribute full vsan vsan-id | name zoneset-name vsan vsan-id | rename current-name new-name vsan vsan-id} Syntax Description activate clone zoneset-currentName zoneset-cloneName name zoneset-name distribute full vsan vsan-id rename current-name new-name Activates a zone set Clones a zone set from the current name to a new name. Maximum length of names is 64 characters. Specifies a name for a zone set. Maximum length is 64 characters. Enables zone set propagation. Activates a zone set on the specified VSAN. The range is 1 to 4093. Renames a zone set. Specifies the current fcalias name. Specifies the new fcalias name. Defaults None. Command Modes Configuration mode. Command History Release 1.0(2) 2.0(x) 2.1(1a) Modification This command was introduced. Added the rename option. Added the clone option. Usage Guidelines Zones are activated by activating the parent zone set. The zoneset distribute full vsan command distributes the operational values for the default zone to all zone sets in a VSAN. If you do not want to distribute the operation values, use the system default zone distribute full command to distribute the default values.The default values are used when you initially create a VSAN and it becomes active. OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 27-23