HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 910

rscn commit vsan Chapter 20 R Commands Send documentation comments to [email protected] rscn commit vsan To apply a pending Registered State Change Notification (RSCN) configuration, use the rscn commit vsan command in configuration mode. To discard a pending RSCN configuration, use the no form of the command. rscn commit vsan vsan-id no rscn commit vsan vsan-id Syntax Description vsan-id Specifies a VSAN where the RSCN configuration should be committed. The ID of the VSAN is from 1 to 4093. Defaults None. Command Modes Configuration mode. Command History Release 3.0(1) Modification This command was introduced. Usage Guidelines If you commit the changes made to the active database, the configuration is committed to all the switches in the fabric. On a successful commit, the configuration change is applied throughout the fabric and the lock is released. Examples The following example commits an RSCN configuration on VSAN 1. switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# rscn commit vsan 1 Related Commands Command rscn abort vsan rscn distribute rscn event-tov clear rscn session vsan show rscn Description Cancels a pending RSCN configuration on a specified VSAN. Enables the distribution of an RSCN configuration. Configures an RSCN event timeout. Clears the RSCN session for a specified VSAN. Displays RSCN configuration information. 20-40 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x