HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 754

line console Chapter 14 L Commands Send documentation comments to [email protected] line console To configure a terminal line, use the line console command. To negate the previously issued command or to revert to factory defaults, use the no form of the command. line console --> databits number | exec-timeout minutes | modem {in | init-string | set-string user-input} | parity {even | none | odd} | speed speed | stopbits {1 | 2} line console --> no databits number | no exec-timeout minutes | no modem {in | init-string {default | user-input} | set-string user-input string} | no parity {even | none | odd} | no speed speed | no stopbits {1 | 2} Syntax Description databits number exec-timeout minutes modem in init-string default set-string user-input string init-string user-input parity even none odd speed speed stopbits 1 2 Specifies the number of databits per character. The range is 5 to 8. Configure exec timeout in minutes. The range is 0 to 525,600. To disable, set to 0 minutes. Enables the modem mode. Enables the COM 1 port to only connect to a modem. Writes the default initialization string to the modem. Sets the user-specified initilization string to its corresponding profile. Maximum length is 80 characters. Writes the provided initialization string to the modem. Sets terminal parity. Sets even parity. Sets no parity. Sets odd parity. Sets the transmit and receive speeds. Valid values for Supervisor-1 modules are between 110 and 115,200 bps (110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600, 115200). Valid values for Supervisor-2 modules are 9600, 19200, 38400, and 115200. Sets async line stopbits. Sets one stop bit. Sets two stop bits. Defaults 9600 Baud 8 databits 1 stopbit 14-6 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x