HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 136

attach Chapter 2 A Commands Send documentation comments to [email protected] attach To connect to a specific module, use the attach command in EXEC mode. attach module slot-number Syntax Description module slot-number Specifies the slot number of the module. Defaults None. Command Modes EXEC mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines You can use the attach module command to view the standby supervisor module information, but you cannot configure the standby supervisor module using this command. You can also use the attach module command on the switching module portion of the Cisco MDS 9216 supervisor module, which resides in slot 1 of this two-slot switch. To disconnect, use the exit command at the module-number# prompt, or type $. to forcibly abort the attach session. Examples The following example connects to the module in slot 2. Note that after you connect to the image on the module using the attach module command, the prompt changes to module-number#. switch# attach module 1 Attaching to module 1 ... To exit type 'exit', to abort type '$.' module-1# exit switch# Related Commands Command exit show module Description Disconnects from the module. Displays the status of a module. 2-16 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x