HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 934

sdv virtual-device name Chapter 21 S Commands Send documentation comments to [email protected] sdv virtual-device name To create a virtual device name for a specified VSAN, use the sdv virtual-device name command in configuration mode. To remove the name, use the no form of the command. sdv virtual-device name device-name vsan vsan-id no sdv virtual-device name device-name vsan vsan-id Syntax Description virtual-device name device-name vsan vsan-id Displays virtual device configuration commands in SDV virtual device configuration submode. Specifies the name of the device. The maximum size is 32. Specifies the number of the VSAN. The range is 1 to 4093. Defaults Disabled. Command Modes Configuration mode. Command History Release 3.1(2) Modification This command was introduced. Usage Guidelines To use this command, you must enable SDV using the sdv enable command. No more than 1000 virtual targets can be created in a single VSAN. No more than 128 devices can be defined as virtual devices. Examples The following example shows how to create a virtual device name for a VSAN, and then specify both the primary and secondary pWWNs. switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# sdv virtual-device name vdev1 vsan 2 switch(config-sdv-virt-dev)# pwwn 21:00:00:04:cf:cf:45:40 primary switch(config-sdv-virt-dev)# pwwn 21:00:00:04:cf:cf:38:d6 The following example shows how to remove the virtual device name. switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# no sdv virtual-device name vdev1 vsan 2 21-16 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x