HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 1464

tcp max-jitter Chapter 23 T Commands Send documentation comments to [email protected] tcp max-jitter To estimate the maximum delay jitter experienced by the sender in microseconds, use the tcp max-jitter command. Use the no form of this command to disable this feature or revert to its factory defaults. tcp max-jitter microseconds no tcp max-jitter microseconds Syntax Description microseconds Specifies the delay time in microseconds ranging from 0 to 10000. Defaults Enabled. The default value is 100 microseconds for FCIP and 500 microseconds for iSCSI interfaces. Command Modes FCIP profile configuration submode. Command History Release 1.3(4) Modification This command was introduced. Usage Guidelines None. Examples The following example configures delay jitter time: switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# fcip profile 3 switch(config-profile)# tcp max-jitter 600 switch(config-profile)# do show fcip profile 3 FCIP Profile 3 Internet Address is 10.3.3.3 (interface GigabitEthernet2/3) Tunnels Using this Profile: fcip3 Listen Port is 3225 TCP parameters SACK is enabled PMTU discovery is enabled, reset timeout is 3600 sec Keep alive is 60 sec Minimum retransmission timeout is 200 ms Maximum number of re-transmissions is 4 Send buffer size is 0 KB Maximum allowed bandwidth is 1000000 kbps Minimum available bandwidth is 500000 kbps Estimated round trip time is 1000 usec Congestion window monitoring is enabled, burst size is 10 KB Configured maximum jitter is 600 us 23-32 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x