HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 594

identity Chapter 11 I Commands Send documentation comments to [email protected] identity To configure the identity for the IKE protocol, use the identity command in IKE configuration submode. To delete the identity, use the no form of the command. identity {address | hostname} no identity {address | hostname} Syntax Description address hostname Sets the IKE identity to be the IPv4 address of the switch. Sets the IKE identity to be the host name of the switch. Defaults None. Command Modes IKE configuration submode. Command History Release 3.0(1) Modification This command was introduced. Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command. Before configuring a certificate for the switch, configure the host name and domain name, and set the identity to be the host name. This allows the certificate to be used for authentication. Note The host name is the fully qualified domain name (FQDN) of the switch. To use the switch FQDN for the IKE identity, you must first configure both the switch name and the domain name. The FQDN is required for using RSA signatures for authentication. Examples The following example shows how to set the IKE identity to the IP address of the switch. switch# config terminal switch(config)# crypto ike domain ipsec switch(config-ike-ipsec)# identity address 10.10.100.231 The following example shows how to delete the IKE identity. switch(config-ike-ipsec)# no identity 10.10.100.231 The following example shows how to set the IKE identity to the host name. switch(config-ike-ipsec)# identity hostname node1 The following example shows how to delete the IKE identity. switch(config-ike-ipsec)# no identity hostname node1 11-2 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x