HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 622

interface gigabitethernet Chapter 11 I Commands Send documentation comments to [email protected] interface gigabitethernet To configure an Gigabit Ethernet interface, use the interface gigabitethernet command. To revert to the default values, use the no form of the command. interface gigabitethernet slot/port cdp enable channel-group group-id [force] isns profile-name interface gigabitethernet slot/port no cdp enable no channel-group no isns profile-name Syntax Description slot/port cdp enable channel-group group-id force isns profile-name Specifies a slot number and port number. Enables Cisco Discovery Protocol (CDP) configuration parameters. Adds to or removes from a PortChannel. The range is 1 to 128. Forcefully adds a port. Specifies the profile name to tag the interface. Maximum length is 64 characters. Defaults Disabled. Command Modes Configuration mode. Command History Release 1.0(3a) 1.1(1a) 1.3(1) Modification This command was introduced. Added the channel-group subcommand. Added the isns subcommand. Usage Guidelines You can specify a range of interfaces by issuing a command with the following example format: interface gigabitethernet1/1space-space2space,spacegigabitethernet3/1space-space2 Examples The following example configures the Gigabit Ethernet interface at slot 4 port 1. switch# config terminal switch(config)# interface gigabitethernet 4/1 switch(config-if)# The following example enters a IP address and subnet mask for the selected Gigabit Ethernet interface. switch(config-if)# ip address 10.1.1.100 255.255.255.0 11-30 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x