HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 293

Chapter 4 C Commands crypto map domain ipsec (configuration mode) Send documentation comments to [email protected] crypto map domain ipsec (configuration mode) To specify an IPsec crypto map and enter IPsec crypto map configuration mode, use the crypto map domain ipsec command. To delete an IPsec crypto map or a specific entry in an IPsec crypto map, use the no form of the command. crypto map domain ipsec map-name seq-number no crypto map domain ipsec map-name [seq-number] Syntax Description map-name seq-number Specifies the map name. Maximum length is 63 characters. Specifies the sequence number for the map entry. The range is 1 to 65535. Defaults None. Command Modes Configuration mode. Command History Release 2.0(x) Modification This command was introduced. Usage Guidelines To use this command, IPsec must be enabled using the crypto ipsec enable command. The sequence number determines the order in which IPsec crypto map entries are applied. Examples The following example specifies entry 1 for IPsec crypto map IPsecMap and enters IPsec crypto map configuration mode. switch# config terminal switch(config)# crypto map domain ipsec IPsecMap 1 switch(config-crypto-map-ip)# The following example deletes an IPsec crypto map entry. switch# config terminal switch(config)# no crypto map domain ipsec IPsecMap 1 The following example deletes the entire IPsec crypto map. switch# config terminal switch(config)# no crypto map domain ipsec IPsecMap OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 4-139