HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 745

Chapter 13 K Commands key Send documentation comments to [email protected] key To configure the preshared key for the IKE protocol, use the key command in IKE configuration submode. To revert to the default, use the no form of the command. key key-id {address ip-address | hostname name} no key key-id {address ip-address | hostname name} Syntax Description key-id address ip-address hostname name Specifies the ID for the preshared key. The maximum length is 128 characters. Specifies the peer IP address. The format is A.B.C.D. Specifies the peer host name. The maximum length is 128 characters. Defaults None. Command Modes IKE configuration submode. Command History Release 2.0(x) 3.0(1) Modification This command was introduced. Added the hostname keyword. Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command. Note The key command supports only the IPv4 format for IP address. Examples The following example shows how to configure the key. switch# config terminal switch(config)# crypto ike domain ipsec switch(config-ike-ipsec)# key ctct address 10.10.100.231 The following example shows how to delete the configured key. switch(config-ike-ipsec)# no key ctct address 10.10.100.231 The following example shows how to set the preshared key for the specified peer. switch(config-ike-ipsec)# key sample hostname node1 The following example shows how to delete the preshared key for the specified peer. switch(config-ike-ipsec)# no key sample hostname node1 OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 13-5