HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 751

Chapter 14 L Commands line com1 Send documentation comments to [email protected] line com1 To configure auxiliary COM 1 port, use the line com1 command. To negate the previously issued command or to revert to factory defaults, use the no form of the command. line com1 --> databits number | flowcontrol hardware | modem {in | init-string {default | user-input} | set-string user-input string} | parity {even | none | odd} | speed speed | stopbits {1 | 2} line com1 --> no databits number | no flowcontrol hardware | no modem {in | init-string | set-string user-input} | no parity {even | none | odd} | no speed speed | no stopbits {1 | 2} Syntax Description databits number flowcontrol hardware modem in init-string default set-string user-input string init-string user-default parity even none odd speed speed stopbits 1 2 Specifies the number of databits per character. The range is 5 to 8. Enables modem flowcontrol on the COM1 port. Enables the modem mode. Enables the COM 1 port to only connect to a modem. Writes the default initialization string to the modem. Sets the user-specified initilization string to its corresponding profile. Maximum length is 80 characters. Writes the provided initialization string to the modem. Sets terminal parity. Sets even parity. Sets no parity. Sets odd parity. Sets the transmit and receive speeds. The range is 110 to 115, 200 baud. Sets async line stopbits. Sets one stop bit. Sets two stop bits. Defaults 9600 Baud 8 databits 1 stopbit Parity none Default init string OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 14-3