HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 792

nasb module Chapter 16 N Commands Send documentation comments to [email protected] nasb module To enable Network-Accelerated Serverless Backup (NASB) in a VSAN and map it to the Storage Services Module (SSM) where the feature is enabled, use the nasb module command in configuration mode. To disable this feature, use the no form of the command. nasb module slot-number vsan vsan-id [control [multiple] | multiple [control]] no nasb module slot-number vsan vsan-idr Syntax Description slot-number vsan vsan-id control multiple Specifies the slot number of the connected module. Configures up to five VSANs to be added to the database. The range is 1 to 4096. Configures a single target LUN that is a Storage Array Controller (Peripheral Device Type 0x0C). Configures up to 10 target LUNs that are the default type, Direct Access Device (Peripheral Device Type 0x00). Defaults Disabled. Command Modes Configuration mode. Command History Release 2.1(1a) 2.1(2) Modification This command was introduced. Added the multiple option. Usage Guidelines This feature must be enabled on the SSM using the ssm enable feature command before you can configure NASB. Examples The following example configures NASB on the SSM installed in slot 4 with a link to VSAN 1. switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# nasb module 4 vsan 1 The following example configures NASB on the SSM installed in slot 4 with a link to VSAN 10, and enables a single target LUN that is a Storage Array Controller (Peripheral Device Type = 0x0C). switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# nasb module 4 vsan 10 control 16-2 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x