HP Cisco MDS 9020 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 312

destination interface Chapter 5 D Commands Send documentation comments to [email protected] destination interface To configure a switched port analyzer (SPAN) destination interface, use the destination interface command in SPAN session configuration submode. To disable this feature, use the no form of the command. destination interface {fc slot/port | fc-tunnel tunnel-id} no destination interface {fc slot/port | fc-tunnel tunnel-id} Syntax Description fc slot/port fc-tunnel tunnel-id Specifies the Fibre Channel interface ID at a slot and port. Specifies the Fibre Channel tunnel interface ID. Defaults Disabled. Command Modes SPAN session configuration submode. Command History Release 1.0(2) 1.2(1) Modification This command was introduced. Added the fc-tunnel parameter. Usage Guidelines The SPAN destination interface must be configured as SPAN destination port (SD port) mode using the switchport command before the interface can be associated with SPAN session as a destination interface. Examples The following example shows how to configure an interface as a SPAN destination port (SD port), create a SPAN session, and then configure the interface fc3/13 as the SPAN destination interface. switch# config terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)# interface fc3/13 switch(config-if)# switchport mode sd switch(config)# span session 1 switch(config-span)# destination interface fc3/13 switch(config-span)# do show span session 1 switch(config-span)# show span session 1 Session 1 (inactive as destination is down) Destination is fc3/13 No session filters configured No ingress (rx) sources No egress (tx) sources switch(config-span)# 5-14 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x