HP LaserJet 5000 Service Manual - Page 194
Reassembly Steps:,
View all HP LaserJet 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Reassembly Steps: 1 Tip the printer back, so that the front faces up. 2 Insert the shaft into the fitting on the right side. Then, angle the shaft into the other side. 3 Place the bushing on the right end of the shaft, and push until the tab locks in the indentation in the shaft. 4 Facing the left side of the printer, orient the shaft so that the open end points away from the solenoid. See Figure 6-44. 5 Depress the solenoid arm, and slide the gear into place. Press it into the plastic collar until it locks in place. 6 Reinstall the spring on the arm of the gear. Figure 6-44 Reassembly of Tray 2 Shaft Item A Explanation Direction to Orient Shaft EN Removing Assemblies 6-55
EN
Removing Assemblies
6-55
Reassembly Steps:
1
Tip the printer back, so that the front faces up.
2
Insert the shaft into the fitting on the right side. Then, angle the
shaft into the other side.
3
Place the bushing on the right end of the shaft, and push until the
tab locks in the indentation in the shaft.
4
Facing the left side of the printer, orient the shaft so that the open
end points away from the solenoid. See Figure 6-44.
5
Depress the solenoid arm, and slide the gear into place. Press it
into the plastic collar until it locks in place.
6
Reinstall the spring on the arm of the gear.
Figure 6-44
Reassembly of Tray 2 Shaft
Item
Explanation
A
Direction to Orient Shaft