HP Scitex LX600 HP Scitex LX Printer Family - Maintenance and troubleshooting - Page 36

Replace the ink collector foams

Get HP Scitex LX600 PDF manuals and user guides View all HP Scitex LX600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

5. Open the carriage cover to access the rear oiler foam. 6. Slide off the cover of the rear oiler foam. 7. Remove the old foam, insert the new foam, and replace the cover. Hardware maintenance 8. Close the carriage cover and the printhead access door. 9. Press the OK key when finished. Replace the ink collector foams There is a single piece of foam in each ink collector. The foam gradually absorbs more and more ink. When the ink reaches the level of the ink collector ribs, it may begin to touch the bottom of the substrate and leave marks on it. At this point, you should replace the foams with new ones. The Absorber Foam Kit (part number Q6703-67047) can be ordered from your service representative. You can minimize delay by ordering it in advance, before you need it. 30 Chapter 4 Hardware maintenance ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
5.
Open the carriage cover to access the rear oiler foam.
6.
Slide off the cover of the rear oiler foam.
7.
Remove the old foam, insert the new foam, and replace the cover.
8.
Close the carriage cover and the printhead access door.
9.
Press the
OK
key when finished.
Replace the ink collector foams
There is a single piece of foam in each ink collector. The foam gradually absorbs more and more ink.
When the ink reaches the level of the ink collector ribs, it may begin to touch the bottom of the
substrate and leave marks on it. At this point, you should replace the foams with new ones.
The Absorber Foam Kit (part number Q6703-67047) can be ordered from your service representative.
You can minimize delay by ordering it in advance, before you need it.
30
Chapter 4
Hardware maintenance
ENWW
Hardware maintenance