HP Scitex LX600 HP Scitex LX Printer Family - Maintenance and troubleshooting - Page 70

Table 10-1 Text messages (continued) Message Recommendation Lower lever Lower the substrate pressure handles. See the User's guide. Maintenance #N advised. Please contact HP You are advised to contact your service representative. See HP Customer Care Centers on page 68. No substrate loaded Load substrate. Out of cleaner roll Replace the printhead cleaning roll. See Replace the printhead cleaning roll and aerosol filters on page 32. Printer cannot carry on printing Check that three-phase power supply is working and the ambient temperature is within the normal range. This problem can also be caused by holes in the substrate, by reflective or transparent substrates or by a dirty or faulty temperature sensor. Printer cannot cool down If the ambient temperature is within the normal range, this problem may be caused by removing the substrate too quickly after printing. Try leaving the substrate in the printer until temperatures settle down after printing. Printer cannot warm up Check that the three-phase power supply is working. This problem can also be caused by holes in the substrate, by reflective or transparent substrates or by a dirty or faulty temperature sensor. Printer waiting for rearm. Press the power button Press the Power Enable button on the lower left of the printer. See the User's guide. Remove {color} printhead Remove the printhead. See the User's guide. Replace {color} cartridge Replace the ink cartridge. See The front panel recommends replacing or reseating an ink cartridge on page 57. Replace {color} printhead Replace the printhead. See The front panel recommends replacing or reseating a printhead on page 57. Replace aerosol filter You are advised to replace both aerosol filters. See Replace the printhead cleaning roll and aerosol filters on page 32. Reseat {color} cartridge Reseat the ink cartridge. See The front panel recommends replacing or reseating an ink cartridge on page 57. Reseat {color} printhead Reseat the printhead. See The front panel recommends replacing or reseating a printhead on page 57.. Select substrate name in the IPS Select the name of the loaded substrate in the HP Internal Print Server. Subs. advance cannot be tracked automatically The substrate-advance sensor cannot track the substrate, and should be turned off. See Substrate-advance compensation on page 8. Substrate jam: remove substrate See The substrate has jammed on page 40. Substrate may be detached from the rear spindle or slippage See The substrate is not attached to the input core detected. Substrate will be unloaded. on page 41. Very low cleaner roll Be ready to replace the printhead cleaning roll very soon. Front-panel errors Table 10-2 Numerical error codes Error code Recommendation 14.2 Three-phase power is unexpectedly off. Call your service representative, and be prepared to answer questions about indicator lights and fuses. See HP Customer Care Centers on page 68. 64 Chapter 10 Front-panel error messages ENWW