HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 104

2 configDefault configDefault Restores system configuration parameters to default values. Synopsis configdefault Description Use this command to reset a subset of configuration settings to their factory defaults. All configuration parameters are reset to their default values with the exception of the following: • Ethernet MAC address, IP address, subnetmask, and boot ROM parameters • IP gateway address • License keys • OEM customization • Product ID and Vendor ID • SNMP configuration • iSCSI configuration • System name • Chassis name • World Wide Name • Zoning configuration (includes aliases, zones, and configurations) • Security parameters and policies • User account passwords (includes all user config and all built-in accounts) • Switch PID format • Ethernet Link Mode Refer to the configure command for more information on default values for configuration parameters. Notes This command cannot be executed on an enabled switch. You must first disable the switch using switchDisable. Some configuration parameters are cached by the system. To avoid unexpected system behavior, reboot the system after executing configDefault. Note that configDefault does not completely remove all FCIP tunnels and GigE IP addresses information. This may be an issue when attempting to use the same information to create new tunnels or modify the existing ones. When issuing configDefault on the Brocade 7500, it persistently disables the ports. The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands none Examples To restore the system configuration to default values: switch:admin> configdefault Committing Configuration ...done. 78 Fabric OS Command Reference 53-1000599-02