HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 561

portSwap 2 portSwap Swaps area numbers of two ports. Synopsis portswap [slotnumber1/]portnumber1 [slotnumber2/]portnumber2 Description Use this command to swap area numbers for a pair of ports. Both ports must be disabled prior to executing this command and the port-swapping feature must be enabled using portSwapEnable. The result of this operation is persistent across reboots and power cycles. To undo a previous port swap, execute portSwap again on the same two ports. portSwap information is kept in its own database; it cannot be manipulated by editing the configuration database displayed by configShow and configUpload. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slotnumber1 For bladed systems only, specify the slot number of the first port whose area number is to be swapped, followed by a slash (/). portnumber1 Specify the number of the first port whose area number is to be swapped, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. slotnumber2 For bladed systems only, specify the slot number of the second port whose area number is to be swapped, followed by a slash (/). portnumber2 Specify the number of the second port whose area number is to be swapped, relative to its slot for bladed systems. Examples To swap area numbers between a pair of ports: switch:admin> portswap 1/3 2/5 portswap done See Also portDisable, portEnable, portShow, portSwapDisable, portSwapEnable, portSwapShow, switchShow Fabric OS Command Reference 535 53-1000599-02