HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 728

2 zone The following operands are supported: objecttype Specifies the zone object type. This operand is supported only with the --create option. To create a TI zone, the value is ti. -o optlist Specifies list of options to control failover mode. If this option is not specified the zone is created, by default, with failover enabled, and the zone will be activated. This operand is supported only with the --create and --add options. Valid Values for optlist are: a Activates the specified zone. d Deactivates the specified zone. n Disables failover mode. In non-failover mode, when the last ISL of a TI Zone goes offline and there is an alternative ISL, the alternative ISL is not used and the switch generates a SCN/RSCN to indicate that no ISL is available. When the ISL of the TI Zone comes online again, the route is set up again and the switch generates another SCN/RSCN. f Enables failover mode. In failover mode, when the last ISL of a TI Zone goes offline and there is an alternative ISL, the alternative ISL is used and the switch does NOT generate any SCN/RSCN. If the ISL of that TI Zone comes online again, traffic is rerouted immediately to the original ISL. name Specifies the name of the zone to be created, added or deleted. -p portlist Specifies the lists of ports to be included, added or removed from a TI zone. The syntax for portlist is "D,I" (Domain, Index). The port list must be enclosed in quotation marks. List members must be separated by semicolons, followed by a space. When you create TI zones over FCR, for a TI within an Edge fabric use "-1"in "I" (of "D,I") in to denote Front and Xlatephantom in the E_Port list. When creating a TI zone within the Backbone fabric specify "Port WWN" in portlist to indicate devices talking across fabrics. --activate | --deactivate name Activates or deactivates TI zones. If more than one zone is specified, the list of zone names must be enclosed in double quotation marks; zone names must be separated by semicolons. --delete name Deletes TI zones from the defined TI zone lists. This command prompts for confirmation. --show [name] Displays zone name, port lists, failover option, and status for the specified zones. Without any specified name, this command displays all TI zones in the defined configuration. 3. Creating and managing RD Zones: --rdcreate Creates a RD Zone for the specified members. The following operands are required: host_wwn Specifies the port world wide name of the host. target_wwn Specifies the port world wide name of the target. vi_wwn Specifies the port world wide name of the virtual initiator (VI). vt_wwn Specifies the port world wide name of the virtual target (VT). 702 Fabric OS Command Reference 53-1000599-02