HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 663

switchCfgSpeed 2 switchCfgSpeed Configures all ports of a switch to a particular speed. Synopsis switchcfgspeed speed_level Description Use this command to configure the speed of all the ports on a switch to a particular level. The configuration is saved in flash memory and persists across switch reboots or power cycles. If any port on the switch is not capable of the specified speed setting, an error message displays for that port. The output of portShow displays the achieved speed level and portCfgSpeed displays the user-configured speed setting. Notes The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands This command has the following operand: speed_level Specify the speed of a port. This operand is required. Valid values are as follows: 0 Auto sensing mode. The port automatically configures for the highest speed. 1 1-Gbps mode. The port is fixed at 1 Gbps. 2 2-Gbps mode. The port is fixed at 2 Gbps. 4 4-Gbps mode. The port is fixed at 4 Gbps. 8 8-Gbps mode. The port is fixed at 8 Gbps. Examples To set the speed level for all ports on a switch: switch:admin> switchcfgspeed 0 Committing configuration...done. See Also portCfgSpeed, portShow Fabric OS Command Reference 637 53-1000599-02