HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 467

portCfgAlpa 2 portCfgAlpa Configures the AL_PA offset on a specified port or range of ports. Synopsis portcfgalpa [slot/]port, mode Description Use this command to set the Arbitrated Loop Physical Address (AL_PA) offset on a port or a range of ports to either 0x0 (default) or 0x13. Changes made by this command are persistent across switch reboots and power cycles. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands When invoked without operands, this command displays the usage. The following operands are supported: slot For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). port Specify the number of the port to be configured, relative to its slot for bladed systems. Use the switchShow command for a list of valid ports. mode Specify a value of 1 to set the AL_PA to 0x13. A value of 0 sets the default AL_PA to 0x0. This operand is required. Examples To configure a port with AL_PA 0x0 (default): switch:admin> portcfgalpa 1/3 0 To configure a port with AL_PA 0x13: switch:admin> portcfgalpa 1/3 1 See Also portCfgShow Fabric OS Command Reference 441 53-1000599-02