HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 497

portCfgTrunkPort 2 portCfgTrunkPort Enables or disables trunking on a port. Synopsis portcfgtrunkport [slot/]port[,] mode Description Use this command to enable or disable trunking on a port. Use switchCfgTrunk to enable or disable trunking on all ports of a switch. When the command is executed to update the trunking configuration, the port to which the configuration applies is disabled and subsequently re-enabled with the new trunking configuration. Traffic through the ports may be temporarily disrupted. Disabling trunking fails if a Trunk Area (TA) is enabled on the port. Use the portTrunkArea command to remove the TA before disabling trunking. Notes Enabling trunking requires an ISL Trunking license. You may disable trunking without a license. The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slotnumber For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). portnumber Specify a port number to be configured, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. portnumber-portnumber Specify a port range, for example 5/3-7. Ports in a range must be separated by a dash ("-"). Spaces between the dash and the ports are not allowed. You can specify multiple port ranges or combine a range of ports with one or more single ports. mode Specify 1 to enable trunking on the specified port. Specify 0 to disable trunking on the port. This operand is required. Examples To enable a port for trunking: switch:admin> portcfgtrunkport 1/3, 1 See Also portCfgShow, portShow, switchCfgTrunk, portTrunkArea, switchShow Fabric OS Command Reference 471 53-1000599-02