HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 356

2 linkCost linkCost Sets or displays the Fabric Shortest Path First (FSPF) cost of a link. Synopsis linkcost [[slotnumber/]portnumber [cost]] Description Use this command to set or display the cost of an interswitch link (ISL). The cost of a link is a dimensionless positive number. The FSPF protocol compares the cost of various paths between a source switch and a destination switch by adding the costs of all the ISLs along each path. FSPF chooses the path with minimum cost. If multiple paths exist with the same minimum cost, FSPF distributes the load among these paths. Every ISL has a default cost that is inversely proportional to its bandwidth. For a 1 Gbps ISL, the default cost is 1000. For a 2 Gbps ISL, the default cost is 500. This simple algorithm is not effective when dealing with trunking ISLs greater than 2 Gbps and less than 1 Gbps bandwidths. Link cost default values are shown in Table 18. TABLE 18 Link cost defaults Link type Link cost (ISL bandwidth in Mbps) < 1 Gbps ISL 2000 1 Gbps ISL 1000 2-Gbps ISL 500 > 2 Gbps trunks 500 4 Gbps ISL 500 8 Gbps ISL 500 10 Gbps ISL 500 When executed without operands, the command displays the current cost of each port on the switch, including non-ISLs. An E_PORT suffix is appended to the interface number of active ISLs. If a static cost is assigned to a port, a STATIC suffix is appended to the link cost. In this case, only the current link cost displays. Use interfaceShow to display both the default and current link costs. Notes This command sets a non-default, "static" cost for any port except EX/VEX ports. Use fcrRouterPortCost to configure EX/VEX ports. The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands When invoked without operands, this command displays the cost for all ports. The following operands are optional: slotnumber For bladed systems only, specify the slot number for which to set or display the cost, followed by a slash (/). portnumber Specify the port number for which to set or display the cost, relative to its slot for bladed systems. Use switchShow to list of valid ports. 330 Fabric OS Command Reference 53-1000599-02