HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 524

2 portLogShow enable Tx & Rx reject busy ctin ctout errlog loopscn OLP LIP LIM BMP OLD TMO Mode: 0 normal; non-zero loopback. Header words 0,1,4 (R_CTL,D_ID,S_ID,OX_ID,RX_ID) and the first payload word. FC-PH reject reason. FC-PH busy reason. Argument 0 is divided into two 16-bit fields: [A] a bit map indicating whether subsequent arguments are valid (0001 means argument 1 is valid, 0003 means arguments 1 and 2 are valid). [B] the CT-based service command code. Argument 1 is the first word of the CT payload, if applicable (as specified in [A]). Argument 2 is the second word of the CT payload, if applicable (as specified in [A]). Argument 0 is also divided into two 16-bit fields: [A] a bit map indicating whether subsequent arguments are valid (0001 means argument 1 is valid, 0003 means arguments 1 and 2 are valid). [B] the CT command code indicating whether an accept (8002) or a reject (8001). If [B] is an accept, argument 1 and 2 represents the first and second words of the CT payload, if applicable (as specified in [A]). If [B] is a reject, argument 1 contains the CT reject reason and explanation code. Error type (refer to errShow). The meaning further depends on each loop state: Offline reason code, usually zero. Reason code for LIPs initiated by FL_Port, if the code value is 800x (x = [1,0xc], see below), or the lower two bytes of the LIP received, if the code value is other than 800x. Usually zero. Memory address for the loop bitmap. Usually zero. Encoded value of the state when loop initialization timed out This value is usually equal to the first word of a loop init frame payload. Other possible values include: 2 LIP (req. INITIALIZING) timeout. 94 F0F0ARB(F0) timeout. 40 CLS timeout. 498 Fabric OS Command Reference 53-1000599-02