HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 458

2 portCfg -p Control L2 CoS Specifies the PL2_Class_of_Service/Priority, as defined by IEEE 802.1p, for the FCIP control connection. Range is 0-7. Default is 0. -P L2 CoS Specifies the PL2 Class of Service/Priority, as defined by IEEE 802.1p, for the FCIP data connection. Range is 0-7. Default is 0. delete tunnel_id Deletes specified FCIP tunnel. qosmap tunnel_id arguments Modifies (or resets to default), the VC to QoS mapping for a particular FCIP tunnel. This table can be modified at any time without bringing down the tunnel. However, the FCIP tunnel must be configured with the fciptunnel create/modify -M option before the actual mapping occurs. The following operands are supported with fciptunnel qosmap: tunnel_id Specifies the tunnel_id. Range is 0-7. -default Resets/sets VC QoS map to default values. -delete Deletes associated QoS map configuration file. Delete QoS mappings before downgrading to pre-v6.0.0 firmware versions that do not support QoS mapping. It removes the file from the config flash memory only. The file is automatically reset to defaults if later used or modified. vc_num When modifying the VC QoS map, specifies the virtual channel ID for which the qosmap is modified. Valid values are 0 - 15. When specifying vc_num, either the -Q or the -P option or both must be specified. -Q dscp Specifies the Differentiated Services Code Point (DSCP) value to be modified. Use the portShow fciptunnel geport all -qosmap command to display current values. Supported range is 0-63. -P l2cos Specifies the L2 Class Of Service (COS) Tagging value. Use the portShow fciptunnel geport all -qosmap command to display current values. Supported range is 0-7. ipif Defines the IP interface for both ports of a tunnel. Up to eight IP interfaces per GbE port are supported. The IP network connection between two 7500 routers or two FC4-18i blades is configured by defining IP interfaces for origin and destination virtual ports, and then defining one or more IP routes to connect them. IPv6 addresses are supported on switches running v6.0 or later. The syntax for portCfg ipif is as follows: portcfg ipif [slot/][ge]port option arguments 432 Fabric OS Command Reference 53-1000599-02