HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 366

2 miniCycle miniCycle Runs a functional test of internal and external transmit and receive paths at full speed. Synopsis minicycle [--slot slotnumber][-nmegs count][-lb_mode mode][-spd_mode mode][-splb_mode 0 | 1] [-ports itemlist] Description Use this command to verify the intended functional operation of an ASIC pair (miniswitch) at the maximum or selected speed by setting up the routing hardware so that frames received by port M are retransmitted by way of port N. Likewise, frames received by port N are retransmitted by way of port M. Each port M sends two frames to its partner, port N. This test is run as a series of eight path tests. Each port on the ASIC pair is exchanging frames with one port on the adjacent ASIC in the same miniswitch. At the end of a path test, the frames are captured and the routing is changed so that each port exchanges frames with the next port on the adjacent ASIC of the same miniswitch. A port is only exchanging frames with one other port at a time under the miniCycle command. All ports are active and exchanging frames simultaneously. The path number being tested determines the partner port N for each port M: path 0: 0-8, 1-9, 2-10, 3-11, 4-12, 5-13, 6-14, 7-15 path 1: 7-8, 0-9, 1-10, 2-11, 3-12, 4-13, 5-14, 6-15 path 2: 6-8, 7-9, 0-10, 1-11, 2-12, 3-13, 4-14, 5-15 path 3: 5-8, 6-9, 7-10, 0-11, 1-12, 2-13, 3-14, 4-15 path 4: 4-8, 5-9, 6-10, 7-11, 0-12, 1-13, 2-14, 3-15 path 5: 3-8, 4-9, 5-10, 6-11, 7-12, 0-13, 1-14, 2-15 path 6: 2-8, 3-9, 4-10, 5-11, 6-12, 7-13, 0-14, 1-15 path 7: 1-8, 2-9, 3-10, 4-11, 5-12, 6-13, 7-14, 0-15 The port numbers are relative to the ASIC pair. This test does not route frames from one ASIC pair to another. Ports cabled to other ports fail if port loopback mode is selected. If port loop back mode is selected, port must have media and loopback plugs installed. For best coverage, you should use self-loopback plugs and port loopback mode (-lb_mode 1) so that each port's external connectivity is tested. The frames are continuously transmitted and received in all ports in parallel. The port LEDs flicker green rapidly while the test runs. For each path, the path test performs the following steps: 1. Clears port statistics and error counters. 2. Enables ports for specified self-loopback mode. 3. Configures the routing table so that when port M receives frames, the frames are routed back to the partner port N and vice versa. 4. Transmits two frames by way of port M and two frames by way of port N. The following four patterns will be used for the four frames, one pattern each: a. 1000 bytes of CSPAT b. 480 bytes of RDRAM_PAT c. 2112 bytes of BYTE_LFSR 340 Fabric OS Command Reference 53-1000599-02