HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 454

2 portCfg portCfg Enables or disables a port's configuration. Synopsis portcfg action [slot/][ge]port [-range] arguments Description Use this command to manage configuration parameters for ports and gigabit Ethernet (GbE) ports. The following operations can be performed with this command: • Optionally add and delete Address resolution protocol (ARP) entries. Flush ARP table. • Create, modify, and delete Fibre Channel over IP (FCIP) tunnels. - Delete, reset, and modify QoS mappings on an existing tunnel. - Create or modify a tunnel with VLAN tagging and Class of Service (CoS). • Configure IP interfaces on the GbE port. • Configure static routes on the IP interface. • Manage registered state change notification (RSCN) suppression on the local port. • Configure a mirror port on the local port. • Configure the FC port for FC Fastwrite. • Modify VLAN Tagging configuration for FCIP. • Manage FICON emulation in an FCIP tunnel. • Configure FTRACE feature. Notes The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Some of the features supported by this command may require a license. For port configuration details and procedures, refer to the respective chapters in the Fabric OS Administrator's Guide. Operands This command supports the following port options: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). [ge]port Specifies the number of the port to be configured, relative to its slot for bladed systems. For GigE ports, the ports are numbered ge0 - ge1. Use the switchShow command for a list of valid ports. This command supports the following actions and associated arguments. If no operand is specified, the command prints the usage. arp Optionally add entries to the address resolution protocol (ARP) table or delete entries from ARP table. Flush entire table. The syntax for portcfg arp is as follows: portcfg arp [slot/][ge]port options arguments Valid options and arguments for arp include: add ipaddr macaddr 428 Fabric OS Command Reference 53-1000599-02